123pugsy
hammer swinger
Last Activity: 06-04-2020, 09:35 AM
Joined: 09-17-2019
Location: MARKHAM, ON
-
............... -
Looks great.Leave a comment:
-
Double mastectomy. I had made 2 blisters, one actually for brake pedal clearance, the other to match it. Round looked too , I don't, not right. Started...
Leave a comment:
-
Made a little tool to planish. It worked OK as it took the "flim flam" out of the panel.
flim flam: adj: the wonkiness that causes panel...Leave a comment:
-
Corner bits. Fusion welding to keep the heat down. Undercuts to be filled. No choice, no matter how I put my head around it, and for it to be sealed....
Leave a comment:
-
Then copy the ally templates in stainless....then with the box ready, time to finish welding the firewall....
...Leave a comment:
-
I brought some aluminum bits home to make templates for the cubby. Enough space for the cruise control unit and the wiper motor in there to boot.
...Leave a comment:
-
Steering gear bracket and bracket for brake assembly. I understand I may get ghost marks in paint from the spot welds but no choice here.
...Leave a comment:
-
Steering gear bracket from 11 ga steel.
...Leave a comment:
-
Firewall chunks.............
...Leave a comment:
-
Clearancing for steering gear unit.......
...Leave a comment:
-
Steering column issues. Cannot use the brakes column too low.
And running outside of header, ridiculous....
...Leave a comment:
-
Firewall parts...........
...Leave a comment:
-
more pics...........cubby door.......
...Leave a comment:
-
Crazy time. With my sore driver's foot, I just had to have hydro boost brakes. I despise the idea of an under floor booster. I also refuse to have it...
Leave a comment:
-
I believe I mentioned earlier about taking a pattern off of something that wasn't correct. I should have learned from the Bondo buck I made for the front...
Leave a comment:
-
The next cowl top section......
...Leave a comment:
-
Reinforcing bits in 11 ga steel. There are 1/4" thick slabs welded on the rear surfaces where the hinges will bolt to.
...Leave a comment:
-
Hinge pocket piece by piece.....
...Leave a comment:
-
A little bit of clean up and then the next bit.
Tape does have it's place.
Excellent for transferring the size and location of the cut on...Leave a comment:
No activity results to display
Leave a comment: