neilb
Administrator
Last Activity: 23-11-20, 12:16 AM
Joined: 13-07-19
Location: Melbourne Australia
-
Berry, i too have a [email protected] wheel. i have trued up my lower anvils (the best i can) on my lathe but have a very good upper wheel, i have added some strength... -
that's not a bad looking glue strip across that ali richard
Leave a comment:
-
cost is irrelevant when it comes to health and safety, pardon the pun but i never blinked twice when i bought my miller tig helmet, having spent some...Leave a comment:
-
personally if it was me i would have another go at making the outer part again, just above your weld line but straight across the lower part of the panel....Leave a comment:
-
i saw that too, i can remember watching a guy tig welding some magnesium headlamp buckets. it was good to watch
-
you are doing well, keep at it
Leave a comment:
-
personally if i was struggling with tracking on aluminium i would probably try using soap, just a light rub over the surface. not had much wheeling experience...Leave a comment:
-
tracking using the english wheel
not sure if anyone has used this tip but while learning how to use the wheel, giving your part a light spray of oil (CRC or WD40) will help with your... -
thank you for sharing your work cliffyLeave a comment:
-
you are doing fine, we all started at the beginning just at different times in life...Leave a comment:
-
i'm not sure to be honest, it could be a subscriber setting but it's not an issue for me to change it anyway happy to help...
Leave a comment:
-
i did have a look and hopefully the change has taken effect lolLeave a comment:
-
i believe its an individual choice but i will have a quick look at your settings is day, month, year your prefered?
Leave a comment:
No activity results to display
Leave a comment: